Build your own projection screen using our configurator and get an instant price.
Your simulator. Your field of view.
Set the room, screen and cockpit together. The planner then calculates the projector class, throw ratio, mounting positions, coverage and cockpit shadowing without recommending a brand.
Your room
Enter internal dimensions, especially the clear height below beams or ceiling fittings. No projectors are shown during screen and cockpit setup.
Move the room around your simulator
Keep the screen and cockpit where you want them, then slide the room around the design to see whether it fits against the walls of a bedroom, garage or training room.
Exact wall distances
The curved screen remains the design origin. Moving the room updates these wall distances automatically; the simulator position below remains relative to the screen.
Define your screen
See 3D preview ↑A continuous cylindrical screen. Preview ranges are guides; manufacturing limits await the STEP assemblies.
Screen and frame only. Projector mounting can be added below.
Simulator position & size
See cockpit in 3D ↑Cockpit dimensions are preset. Position your cockpit here, then configure the screen. Change the cockpit size below only if you have a custom size.
Height from the floor to the bottom of the cockpit reference, for example a platform or taller base. Zero places it on the floor. Your cockpit dimensions and the screen height stay unchanged.
Change the size of your cockpit
Only change these dimensions if your cockpit differs from the supplied model.
Planning reference only. Actual clearance and structural suitability must be checked.
Calculate the projector specification you need
The planner calculates a matched projector layout from your screen, cockpit and room geometry. Simworx does not recommend a make or model here; use the resulting specification to source a projector that meets the requirement.
Ceiling mounts are shown as generic drop mounts from the calculated lens positions. Choose truss to visualise a floor-supported truss below the ceiling. Truss adds €1,000 to the Simworx quote.
Layout preferences
The cockpit stays at its chosen position. Any screen-size change is listed with the result.
Projector specification required
Use these optical requirements to source a suitable professional projector. Simworx is specifying the geometry required, not endorsing a particular brand or model.
Improve this configuration
Mounting geometry
Lens centres are measured from the room’s left wall, front wall and floor. Confirm the chosen projector chassis datum with its supplier before drilling or fabricating mounts.
| Projector | From left wall | From front wall | Lens height | Aim yaw / pitch |
|---|
Planning geometry only. Verify the selected projector’s throw range, lens offset, focus range, chassis datum and mounting orientation with its supplier.
Position, swivel & throw
Select a projector, position it, swivel/tilt it and adjust throw. The beam and visible coverage update using the existing V24 optics engine.
If the required throw becomes unrealistic, move the projector, cockpit or screen before quoting the installation.
Projector position, swivel & throw
Select a projector and move it left/right, raise/lower it, move it forward/back, then swivel it with yaw, pitch and roll. Use Move or Aim for the existing 3D handles. Adjust throw ratio to widen or narrow the beam until the room geometry works. The result remains a brand-neutral projector requirement.
Required throw ratio
Lower throw ratio gives a wider image from the same lens-to-screen distance. Use this after physically positioning the projector to determine the optical specification the room needs.
Design check: if acceptable coverage cannot be achieved within a realistic throw ratio, move the projector, cockpit or screen before committing the customer to the installation.
Tell us about your installation.
Include ceiling limits, cockpit access, ambient light and any existing projector equipment.
Your specification & quote
Design review
The quote keeps the screen, optical profile and tariff versions with your configuration.
Projection system proposal
Final technical configuration and Simworx commercial estimate.
System specification
Projector requirement
| Projector | Lens position | Aim | Throw |
|---|
Projectors are customer sourced and are not included in the Simworx commercial total. Final projector/lens suitability must be confirmed with the projector supplier before purchase.